When searching online, most of the information I found simply recommended doing a custom bent steel line if the distance or angle is awkward, but I would rather just take the simpler approach if possible. fittings, these solid brass connectors effortlessly connect and disconnect with any garden hose accessories and water sources. Some professional or high-flow hoses are 3/4 11.5NH while some cheaper hoses are 1/2 11.5NH. This set includes 6 female and 6 male water hose quick connect faucet adapters, along with 12 rubber hose washers for a secure, leak-free connection. I wasn't sure, however, if this configuration is actually better since I don't know what kind of bend these things can handle in a practical scenario and whether it is better to have the bend in the pipe, or at the connector. Most residential garden hoses have a 5/8 internal diameter with 11.5NH or 11.5 threads per inch. For this reason, I was going to replace the 12 inch lines for the longest available so I can make a loop, like this: Function: faucet supply hose transfers water securely from water supply to faucet or toilet etc. yet, but I am concerned about long term wear from having it in this configuration. I purchased 12 inch lines since the distance between the faucet and the valve is slightly less than 12, but when I installed them, the shorter distance caused a fairly tight bend in the middle and where the mesh meets the connector: I installed new faucets and used the standard flexible lines for the water connections.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |